Feiss VS53003 Manuel d'utilisateur télécharger pdf

Installation Instructions for

Align the anchors with the mounting plate holes and install them by pushing them into the wall.

Secure the mounting plate to the electrical box with two mounting plate screws.

Screw the anchor screws into the anchors.

Connect the fixture to a suitable ground in accordance to local electrical codes.

Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.

Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.

Neatly place all the wires into the electrical box, mount the fixture base onto the mounting plate, and secure it with the fixture

screws using an Allen wrench.

Screw the finial to the bottom of the fixture.

Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.

Install the shade by properly placing it over the socket and secure it in place by mounting it onto the corresponding fixture hook.

Repeat steps 8-10 for remaining sockets.

LAMP

HOT WIRE

BLACK WIRE

ELECTRICAL BOX

MOUNTING

PLATE

NEUTRAL WIRE

WHITE WIRE

GP I :ENERAL RODUCT NFORMATION

This product is listed by one of the following

“ ationally ecognized esting aboratory”NR TL

This product is suitable for damp locations.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

SOCKET

SHADE

FIXTURE SCREW

FINIAL

Monica 2 and 3 Light Vanity Strip

1.1

VS53002-VS53003

V 53002, V 53003_SS

Vanity Strip

HOOK

ANCHOR

SCREW

ANCHOR

ALLEN WRENCH

MOUNTING

PLATE SCREW

1 2 3 4

Résumé du contenu

Page 1 - Vanity Strip

1Installation Instructions forAlign the anchors with the mounting plate holes and install them by pushing them into the wall.Secure the mounting plate

Page 2

2Alignez les ancres avec les trous de la plaque de montage et les installer en les poussant dans le mur.Fixez la plaque de montage à la boîte électriq

Page 3

3Alinear las anclas con los orificios de la placa de montaje e instalarlos empujándolos hacia la pared.Fije la placa de montaje a la caja eléctrica co

Page 4 - SAVETHESE INSTRUCTIONS!